| WPV |
Water
protection valve for gas boat fuel tanks. Prevents
water entering the fuel tank in the event of a capsize etc. This has a
brass and stainless steel valve with a float inside the plastic
container. It is connected to the air inlet to the tank. If the boat
fills with water the float rises to the top and closes off the valve, if
the boat capsizes the float drops and closes off the valve. We have used
this on our racing boats for years and it is 100% effective. |
  |
£19.95
 |
| GA25 |
Rubber
bellows for radio linkages. (4). Pack of 4 bellows..
|
 |
£3.25
|
| GA26 |
Rubber
bellows for radio linkages through transom to rudder or radio box.. (2).
Pack of 2 bellows of a new improved type, the best we have
found. 13mm diameter with 10mm hole one end and 1.5mm hole the other.
35mm long |
 |
no
stock
£2.95
|
| GA27 |
2
x Rubber bellows large diameter for radio linkages. With glue in type aluminium base part.
|
 |
no stock
£7.95
|
| GA28 |
2
x Rubber bellows small diameter for radio linkages. With glue in type
aluminium base part.
|
 |
£3.95
|
| GA29 |
Aluminium
horizontal exhaust mount for 40mm tuned pipe for use on FSRV and mono's
(Prestwich 27cc 15cc pipe |
 |
no stock
£15.50
|
| GA29A |
Aluminium
horizontal exhaust mount for 50mm tuned pipe for use on mono's (CS28
pipe) |
|
no
stock
£14.50
|
| GA30 |
Aluminium
exhaust mount with rubbers 36mm id. |
 |
no
stock
£16.95
|
| GA31 |
Aluminium
vertical exhaust mount with rubbers 40mm id. |
|
no stock
£18.95
|
| GA32 |
Aluminium
exhaust mount with rubbers 44mm id. |
 |
£21.95
|
| GA34A |
PMB
Glowswitch. The best programmable glowswitch for up to 7 amps. Plugs
into a Y lead on the throttle servo and switches on the power to
the glowplug. Programs easily so that at lowest throttle it is off, at
any other position (say 1/8 throttle) it is on and stays on until at a
point just below full throttle ( programmed by you), it switches off.
Simple single pushbutton setup and setup is retained in the memory. |
  |
£39.95
|
| GA35 |
Aluminium
servo mount clamp type for all MINI servos such as Hitec 225 (servo not
included) |
  |
£8.95
|
| GA36 |
Aluminium
servo mount clamp type for all standard servos. (servo not included) |
 |
£6.95
|
| GA37 |
Aluminium
servo mount clamp type for all 1/4 scale 1/5th servos. (servo not
included)
NEW
|
|
£7.95
|
| GA38 |
Servo
mount for standard servos, L type aluminium CNC with screws etc.
|
  |
£4.95
|
| GA39 |
Dual
aluminium servo mount for standard servos
|
 |
£7.95
|
| GA41 |
Aluminium
servo mount vertical type for all standard servos with 40mm long bodies.
(servo not included) |
 |
£7.95
|
| GA43 |
Aluminium
lightweight, streamlined strong handle for the side of monos to
help with launching.
|
 |
£5.95
|
| GA44 |
Hatch
fastening clips/cowl locks, push down and turn to lock, turn to release.
Anodised aluminium. (2 pcs)
|
  |
£7.50
|
| GA44A |
MINI
Hatch fasteningclips/cowl locks, push down
and turn to lock, turn to release. Anodised aluminium. (2 pcs)
small enough for FSRV boats, nitro and brushless boats |
  |
£6.95
|
| GA45 |
O-ring
type hatch fastening clips/cowl locks. Billet aluminium with all
stainless screws and nuts. (2 sets) |
 |
£6.95
|
| GA45A |
O-ring
spares for GA45 6 pcs |
 |
£2.50
|
| GA46 |
2 x
spring loaded hatch clips (2) 26mm long x 16mm wide x 812mm
high plus pin 15mm long. |
 |
3.50
|
| GA47B |
10
sets of button head M4 12 button socket head screws and steel threaded
fittings for fuel tank cover and wing fitting. |
 |
£2.75
|
| GA47A |
6
anodised aluminium M4 thumbscrews 16mm long thread |
 |
£5.30
|
| GA47C |
6
anodised aluminium M4 thumbnuts |
 |
£3.95
|
| GA48 |
2.4g
extended aerial. Plug directly into Multiplex, Hitec, Sanwa, Graupner,
FRsky or Futaba receivers. 350mm long |
 |
£3.95
|
| GA49 |
Radio
box access screw in access assembly. Waterproof .
|
   |
£2.95
|
| GA50 |
Radio
box access bung. Waterproof .
|
 |
£4.95
|
| GA51 |
Fuel
nozzle for gas boats. Aluminium with magnetic catch and rubber seal |
  |
£9.45
 |
| GA52 |
Small
stainless steel polished airscoop/vent. 44mm long 41mm wide 16mm deep |
 |
£2.20
|
| GA53 |
Large
stainless steel polished airscoop/vent. 54mm long 51mm wide 16mm deep |
|
£2.30
|
| GA55 |
Radio
hatch, radio box box tape. 20mm wide waterproof clear tape for radio
box sealing and hatch sealing on electric boats. 10metres |
 |
£3.25
|
| GA57B |
4 x
short radio tray mounting feet aluminium M4 15mm long |
 |
£4.80
|
| GA58 |
4 x
long radio tray mounting feet aluminium M4 30mm long |
 |
£5.50
|
| GA58A |
4 x
long radio tray mounting feet aluminium M3 30mm long |
|
£5.50
|
| GA59 |
cnc
aluminium radio cover fixing.M4 threaded for fixing under the deck 13mm
long. The end is blanked off to stop waterleaks into radio compartment. |
 |
£1.60
|
| GA59A |
Fuel
tank mounting. M4 thread, 16mm high
|
 |
£2.95
|
| GA59B |
1 x
Lightweight hatch fitting M3 thread, 6.25mm high, 12mm
diameter
|
  |
No
stock
£1.60
|
| GA59C |
1 x
Lightweight hatch fitting M4 thread, 6.25mm high, 12mm
diameter |
|
£1.60
|
| GA61 |
Boat
aerial tube type, suitable for 2.4ghz and 40mhz. Aerial wire fits
up inside the tube. 300mm long black
base , black tube |
 |
£3.95
|
| GA61A
|
Boat
aerial tube type, suitable for 2.4ghz and 40mhz. Aerial wire fits
up inside the tube. 300mm long red base red tube |
. |
£3.95
|
| GA61B
|
Boat
aerial tube type, suitable for 2.4ghz and 40mhz. Aerial wire fits
up inside the tube. 300mm long. gold base, yellow tube |
. |
£3.95
|
| GA61C |
Boat
aerial tube type, suitable for 2.4ghz and 40mhz. Aerial wire fits
up inside the tube. 300mm long green base, green tube |
.
|
£3.95
|
| GA61D |
Boat
aerial tube type, suitable for 2.4ghz and 40mhz. Aerial wire fits
up inside the tube. 300mm long blue base, blue tube |
.
|
£3.95
|
| GA63 |
Starter
V belt. Brown, kevlar, cogged, reinforced type. 6mm x 520mm. Suitable
for all engines .18 to .91 |
 Click
here for engine Equipment |
£3.75
|
| GA65 |
High
quality waterproof push pull radio switch for futaba, hitec, sanwa,
multiplex etc. |
  |
£12.95
|
| GA66 |
Waterproof
radio switch for futaba, hitec, sanwa, multiplex etc. includes charging
lead |
   |
£8.95
|
| GA70 |
Servo
arm cnc aluminium 25T for Futaba, savox, and many others. M3 threads |
 |
£1.95
|
| GA70A |
Servo
arm heavy
duty with M3 threads. CNC aluminium 25T for Futaba, savox, and many
others |
 |
£2.30
|
| GA70B |
Double
Servo arm with M3 threads. CNC aluminium 25T for Futaba, savox, and many
others |
 |
£2.45
|
| GA73 |
D
section closed cell sealing foam for radio hatches etc. Fix
with cyano or impact adhesive |
 |
£5.95
|
| GA75 |
O
section ( 6mm dia) closed cell sealing foam for radio hatches etc.
Fix with cyano or impact adhesive. Much better seal than D section. |
|
£2.95
|
| GA76 |
Neoprene
closed cell sealing foam for radio hatches etc. Self adhesive and bends
around corners. 12mm wide 5mm thick. 950mm long |
|
£4.95
|
| GA77 |
Autobailer
one way valve for removing water from inside the boat |
 |
£5.80
|
| GA79 |
Aluminium
deck hook |
 |
£5.95
|
| GA82 |
Aluminium
deck handle silver |
 |
£6.95
|
| GA85 |
Carbon
plate for servo mounts etc. , very stiff. 200mm x 140mm x 2mm
thick, shiny both sides. Made with prepreg carbon .
|
 |
£16.95
|
| GA90 |
Carbon
angle shiny both sides. 2mm x 190mm x 15mm x 15mm for radio bars, servo
mounts etc.
|
 |
£19.25
|
| GA91 |
Carbon
angle shiny both sides. 2mm x 190mm x 25mm x 25mm thick for radio bars,
servo mounts etc.
|
|
£19.95
|
| GA92 |
Carbon
angle shiny both sides. 190mm x 15mm x 15mm x 1mm thick for
radio bars, servo mounts etc.
|
|
£16.95
|
| GA93 |
Carbon
angle shiny both sides. 190mm x 25mm x 25mm x 1mm thick
for radio bars, servo mounts etc.
|
|
£17.95
|
| GA95 |
Electric
water or fuel pump 6v to 12 volt. (suitable for nitro fuel or petrol) |
 |
£17.95
|
| GA113 |
10
plated steel spring clips for 6mm to 7mm od silicone tubing
|
  |
£2.35
|
| GA114 |
10
plated steel spring clips for 7mm to 8.5mm od silicone tubing
|
 |
£2.35
|
| GA124 |
Silicone
exhaust tube. High temperature 100mm long. 13mm, inside. |
 |
£2.30
|
| GA124A |
Silicone
exhaust tube. High temperature 100mm long. 16mm, inside. |
|
£2.50
|
| GA125 |
Silicone
exhaust tube suitable for high temperature. 100mm long. 19mm inside. |
 |
£3.00
|
| GA126 |
Silicone
exhaust tube suitable for high temperature. 100mm long. 22mm
inside. |
 |
£3.95
|
